Fluid 3D Workshop

Hexagonal Natural MDF Bases (22mm) (3mm Round hole x1) x14


Item number F3D-1565-9873

* Incl. VAT excl. Shipping

Precision cut high quality 22mm hexagonal mdf bases for mounting your miniatures. These bases include a number of pre-cut holes.

The hole is configured as 1x 3mm round hole positioned 4mm in and 0mm along, clockwise from the center of edge 0. N.B. Measurements regarding position of holes are relative to the centres of the holes.

These bases are available in thicknesses of 2.2mm & 3.2mm and are supplied in a convenient sprue (sheet) and simply need to be popped out when needed (and may need trimming slightly before use.)

If you cannot see a base size, shape, or colour to suite your needs, please send us a message - we manufacture all our bases in our workshop and are constantly expanding our product portfolio.

IMPORTANT: A note on thickness...

While we offer many of our bases in different thicknesses, care should be taken to choose the thickness most suitable to your needs. In particular, our 1mm acrylic is very soft and only suitable for gaming bases up to approximately 20mm. In general, we recommend 2mm thickness as a starting point unless you have specific needs. Please see below for information regarding suitability for basing miniatures at each thickness. This information should be used as a guide only...

1mm:Suitable for gaming up to 20mm, display up to 40mm, may not be suitable over 40mm.
2mm:Suitable for gaming up to 60mm, display up to 130mm.
3mm:Suitable for gaming and display at any size.
4mm:Suitable for gaming and display at any size.

And finally, while we use the best quality materials possible, due to the nature of manufacturing processes for our raw materials, the thickness of our mdf is approximate and can vary by +/- 15%