Precision cut high quality dark brown acrylic movement trays for easily moving your miniatures in groups.
These movement trays have a 4mm ridge around the edge to stop figures sliding off while moving, are available in a thickness of 3mm, and are supplied in a sheet requiring assembly before use. Select the size you require for the standing area and note the additional 4mm ridge adds 8mm to the overall dimensions. The ridge height is the same as the thickness you choose for the tray. All our acrylic products are shipped covered with a protective film to prevent scratches during transit and when stored - this film MUST be removed before use. When removing the film, we advise against the use of sharp tools, and recommend scratching at the edge gently with a finger nail. If in doubt, please message us for further advice.
Please be aware, some vendor bases (partucularly injection moulded plastic bases) are a fraction larger than advertised. Laser cut products can be very accurate so to avoid dissapointment due to discrepancies in other vendor products, before making your selection, please arrange your figures in formation and measure the footprint of the group. If in doubt, add a few mm to ensure the trays you purchase are large enough.
To assemble your movement trays, simply glue the edge strips to their relative edges using a suitable glue allowing time for it to dry completely. For acrylic we recommend a little cyanoacrylate (general super glue.)
If you cannot see a tray size or colour to suite your needs, please send us a message - we manufacture all our acrylic products in our workshop and are constantly expanding our product portfolio.
IMPORTANT: A note on thickness...
While we offer our movement trays in different thicknesses, care should be taken to choose the thickness most suitable to your needs. In general, we recommend 2mm thickness for lighter resin based miniatures, and 3mm thickness for heavier metallic miniatures.
And finally, while we use the best quality materials possible, due to the nature of manufacturing processes for our raw materials, the thickness of our acrylic is approximate and can vary by +/- 5%